GPU Holder for RTX 4070 [mini-project]
Stop your massive GPU from flopping about and always ruining your Motherboard PCI connectors.
GPU Holder for RTX 4070 [mini-project] Read More »
Project Posts
A collection of our member’s projects.
Open Scraper [mini-project]
OpenScraper is a project of mine that came to being because of a request from a relative. She works as a professor of marketing at a university in France and needed data for further analysis (for example sentiment analysis for a new product release). So she asked me whether I could code her a simple
Open Scraper [mini-project] Read More »
Ultimate CR-10 3D-Printer Upgrades
What were the problems? Always needing to adjust the bed leveling (BL-Touch, new Control Board for custom Marlin config) X-axis is sloped due to only one Z-rod (Dual Z) Z-axis easily jams once a bit of force is put on it (Anti-kickback springs, linear rails) As the 3D printer is usually in my cellar, I
Ultimate CR-10 3D-Printer Upgrades Read More »
Moonlight – Stream
This project is about streaming with “Moonlight” In this context streaming doesnt mean just watching whats on your homescreen. It means remote controlling your pc with low latency and good enough resolution/refresh-rate to even allow for remote play. A bit of backstory: Nvidia developed a protocol to stream gameplay from an RTX GPU to a
Moonlight – Stream Read More »
3D-Printing with special curves [mini-project]
Excelerate rapid prototyping with 2D-Printing! (also called printing)
3D-Printing with special curves [mini-project] Read More »
Pi – Hole
Pi-Hole is a free DNS blocker that can be used to block the IP Addresses of Ads, Tracker, Telenometrie and more. This results in a improved browsing experience, more safety and more privacy. 1) Prerequisites 2) Installation 3) Configuration 1) Prerequisites: – Hardware You need some thing to run pi-hole on. Whether that is a
Shotland Modular v1 [FAIL]
My first try at making Shotland, my robot Bartender more modular. Everything fits together like a Lego set, except for the electronics which would require more space.
Shotland Modular v1 [FAIL] Read More »
Roboost V2
Version 2 of my Roboost project! As you’ve seen in the previous post, the former version had quite a few problems, although it wasn’t finished completely. So after finishing school, I decided to tackle the issue again. This time, I did not only want to do the programming, but I also wanted to learn more
DIY SmartHome Sensor [mini-project]
DIY Temperature Sensor for SmartHome with ESPHome
DIY SmartHome Sensor [mini-project] Read More »