Donation Box [mini-project]
A Donation Box that plays silly souds when donations are made.
Donation Box [mini-project] Read More »
3D Printing
Projects involving 3D-Printing
First Mobile Robot [mini-project]
In this post, I just quickly wanted to showcase my very first mobile robot. It was built for my informatics class in HTL, but I had so much fun developing it that I brought it home to continue playing with it. It uses five ultra sonic sensors to do really basic collision avoidance, controlled by
First Mobile Robot [mini-project] Read More »
GPU Holder for RTX 4070 [mini-project]
Stop your massive GPU from flopping about and always ruining your Motherboard PCI connectors.
GPU Holder for RTX 4070 [mini-project] Read More »
Ultimate CR-10 3D-Printer Upgrades
What were the problems? Always needing to adjust the bed leveling (BL-Touch, new Control Board for custom Marlin config) X-axis is sloped due to only one Z-rod (Dual Z) Z-axis easily jams once a bit of force is put on it (Anti-kickback springs, linear rails) As the 3D printer is usually in my cellar, I
Ultimate CR-10 3D-Printer Upgrades Read More »
3D-Printing with special curves [mini-project]
Excelerate rapid prototyping with 2D-Printing! (also called printing)
3D-Printing with special curves [mini-project] Read More »
Shotland Modular v1 [FAIL]
My first try at making Shotland, my robot Bartender more modular. Everything fits together like a Lego set, except for the electronics which would require more space.
Shotland Modular v1 [FAIL] Read More »
Roboost V2
Version 2 of my Roboost project! As you’ve seen in the previous post, the former version had quite a few problems, although it wasn’t finished completely. So after finishing school, I decided to tackle the issue again. This time, I did not only want to do the programming, but I also wanted to learn more
DIY SmartHome Sensor [mini-project]
DIY Temperature Sensor for SmartHome with ESPHome
DIY SmartHome Sensor [mini-project] Read More »
Roboost V1
Logo by Paul Hello all! In this post, I will give you an introduction to the Roboost project – what it is, a summary of version one, and where the project is going – will be included. If you’re into robotics and are not afraid of a bit of maths, this post is for