Ultimate CR-10 3D-Printer Upgrades
What were the problems? Always needing to adjust the bed leveling (BL-Touch, new Control Board for custom Marlin config) X-axis […]
Ultimate CR-10 3D-Printer Upgrades Read More »
What were the problems? Always needing to adjust the bed leveling (BL-Touch, new Control Board for custom Marlin config) X-axis […]
Ultimate CR-10 3D-Printer Upgrades Read More »
This project is about streaming with “Moonlight” In this context streaming doesnt mean just watching whats on your homescreen. It
Moonlight – Stream Read More »
Excelerate rapid prototyping with 2D-Printing! (also called printing)
3D-Printing with special curves [mini-project] Read More »
Pi-Hole is a free DNS blocker that can be used to block the IP Addresses of Ads, Tracker, Telenometrie and
My first try at making Shotland, my robot Bartender more modular. Everything fits together like a Lego set, except for the electronics which would require more space.
Shotland Modular v1 [FAIL] Read More »
Version 2 of my Roboost project! As you’ve seen in the previous post, the former version had quite a few
DIY Temperature Sensor for SmartHome with ESPHome
DIY SmartHome Sensor [mini-project] Read More »
Logo by Paul Hello all! In this post, I will give you an introduction to the Roboost project –
Version 2 of the robot Bartender with 2 more Pumps and therefore infinitely more capabilities.
Shotland v1 is a robot Bartender that can mix more than 20 drinks by combining 6 ingredients.
In this article, we describe how to use DOPE, a deep neural network for 6-degree-of-freedom (6DoF) object pose estimation. We provide step-by-step instructions for installing and using DOPE to estimate the pose of objects in 3D space. This technique is useful for a variety of applications, including robotics and augmented reality.
6DoF pose estimation using DOPE Read More »